The M16 rifle is a gas used, air-cooled, magazine fed rifle in bursts of three rounds and semi-automatic piece to be fired. The weapon consists of an M16 rifle, magazines and sling. The M16 was introduced in 1960 and was the first infantry rifle for the U.S. Army until 2010, when he became withdrawn from circulation. Members of the service are necessary to remove and replace their M16 rifles for the regular maintenance and cleaning. There were four models of the M16 rifle, but the instructions for disassembly and assembly of each model are the same.
Disassembly : Remove the harness from the stock and barrel with metal buckles of the harness of the gun to remove. Hold the gun at his butt. Press the ring and pull the hand guards free. Push the rear takedown pin all the way. Turn off the receiver at the top, to separate it from the bottom of the receiver. It is also known as “shot gunning” the rifle known. Push receiver pin down and completely separate upper and lower receiver.
The M16 rifle airsoft gun a challenging mimics the appearance of an M16 rifle with such precision that it almost as fast as bullets real cannon fires balls of fire. It is recommended that the airsoft m16 right after cleaning, so that dirt and dust into the trash and do not cause problems with their work to collect on. You need the same tools that are used by state to disassemble the weapon. Assembly airsoft M16 is about the same amount of time it takes to hand, or can even be faster.
The hammer flat on the back edge of the rifle. Place the butt against the rock and place into the slot on the rear edge. Use a Phillips screwdriver, the screws that fit under the seat where it meets the hammer sure.
Peace M16 horizontally through the cloth with the gun barrel against the left.
The cartridges of the change before the assembly on the frame M16 trigger guard on the left. Tighten the screws on the entire cartridge magazine band with a screwdriver.
Insert the stylus that fits the opening frame on the opposite side of the M16 sites through the hole in the front of the trigger. Insert the pin into the hole on the opposite side of the frame and M16 through the hole in the front of the magazine, cassette exchange.
Place the receiver on top front of the M16. Slide the upper receiver to the rear of the chassis.
And semi-automatic mode is cooked at a high rate of fire to give you real-time simulation AEG airsoft gun with an M16. get more airsoft m16 and airsoft m14 in site airsoft m14